D65 Manual

List of Screws and Pads

Assembly process（Hot-swap Version）

Step 1：Gaskets

First use 16 gaskets to stick the protruding part of the plate along the edge, Make sure it’s neatly pasted. 1. The only thing to pay attention to is to use the shortest gaskets for the arrow keys area. Paste it on the right, otherwise it will affect the blocker.

gaskets installation position indication diagram

Note:Black and Green are of different widths

Step 2：Plate Screw

#1 M2-3---Plate

#5 M2-3(Standoff)

Step 3：Stabilizers

Take out the PCB and plug in the data cable, open the VIA to test (touch the hot-swappable solder joints on the back with tweezers), make sure the PCB is intact, and then assemble it, take out the satelliters and install them in the style shown below!

Step 4：PCB foam

Step 5：PCB screw

#2 M2-3 screw---PCB

Step 6：Switches

Press the switches you prepared to the fixed pcb in the correct direction make sure that the switches pins are not bent when pressing, after allinstalled, open the VIA test one more time.

Step 7：Top case

Place the assembled PCB on the upper piece in the direction shown in the figure below, paying attention to the USB interface.Don't pretend to be crooked. And add the another foam at the same time!

Step 8：Bottom Case foam

Step 9：Bottom case

Step 10：All screws

#3 M2-8 ---Case

#4 M2-4 ---Brass weight

After installing the bottom case, screw the #3 M2-8 cup head 6-bobes recess screws to the bottom case, and the brass weight screw is #4 M2-4 cup head 6-bobes recess, and finally stick the black round foot pad on.